Oase Aquarius Eco Expert 22000 Notice D'emploi page 19

Install the unit at a dry place
• Aquarius Eco Expert 22000/28000: Hoses or pipes can be connected at the inlet and outlet. Recommendation:
– Up to 5 m length: Use 50 mm (2") hose connectors and hoses. (→ Connecting the hose)
– From 5 m length: Use DN 75 or DN 100 pipes. (→ Connecting the pipe)
• Aquarius Eco Expert 36000/44000: A pipe is connected to the inlet. A hose or a pipe can be connected to the outlet.
Recommendation:
– Up to 5 m length: Use 50 mm (2") hose connectors and hoses. (→ Connecting the hose)
– From 5 m length: Use DN 75 or DN 100 pipes. (→ Connecting the pipe)
Adhere to the following conditions for dry installation:
 D
• Swimming pond or pool that may be accessed by people.
– Install the unit at least 2 m away from the water.
• Do not expose the unit to direct sunlight.
• Ensure that the pump is in a secure and stable position.
• Adhere to the maximum permissible ambient temperature. Ensure forced cooling if necessary. (→ Technical data)
Connecting the hose
How to proceed:
 F
1. Remove the screws for fastening the filter basket and remove the filter basket.
2. Screw the hose connector with union nut and seal onto the inlet.
3. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
4. Screw the hose connector with union nut and seal onto the outlet.
5. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
6. Fasten the pump to a suitable base using screws (not included in the scope of delivery).
Connecting the pipe
• Aquarius Eco Expert 22000/28000/36000/44000: To connect the pipes, one PVC transition sleeve each is required.
PVC transition sleeves are available in specialised shops.
How to proceed:
• Screw the PVC transition sleeve and seal onto the outlet.
• Attach the PVC transition sleeve to the pipe.
Connecting
As an option, Eco Control can be connected to the pump to control it.
• The control unit Eco Control (47673) is available as an accessory for Eco Expert pumps.
• If the pump is integrated in an EGC network, connecting Eco Control is not possible.
How to proceed:
 J
1. Remove the protection cap from EGC-IN.
2. Fit the plug connector of the cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
- EN -
19