Cleaning And Maintenance; Technical Features - EXALTA EL-310 Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
The charging light does not go out or change colour when the appliance is fully
charged.
To use the hair clipper connected to the mains: switch the hair clipper off, connect
it to the mains and wait a few seconds before switching it on.
CUTTING LENGHT ADJUSTMENT
The Hair Clipper is provided with 4 cutting guides, necessary to adjust the cutting
length from 0,8mm (without cutting guide) to 12 mm (with cutting guide).
WARNING:when you fit or remove the cutting guide, the appliance should always
be off.
Choose and attached the cutting guide according to the hair length you prefer
The cutting length is shown in the inner side of each cutting guide.
In order to put the preferred cutting guide, just attached it in the supports placed
in the two sides of blades (as shown in the picture here-below)

CLEANING AND MAINTENANCE

Before starting cleaning the appliance, always switch it off and unplug it.
Never immerse the appliance in water.
Clean the unit with a damp and soft cloth.
Never use detergents and solvents to clean the appliance.
After having used the appliance remove the cutting guide and using the cleaning
brush to clean the body of the device, in order to remove any hair from the cutting
blade.
In order to grant a long and good performance to the appliance, it is advisable to
clean and oil often the appliance.
For an easy cleaning it is possible to remove the cutting blades.
Open the cutting unit by pushing it backwards (as shown in the picture).
Remove hair from the cutting blade using the cleaning brush, reassemble the
cutting unit, put 2 o 3 oil drops and allow the machine to run for several seconds
so that the unit can lubricate properly.
SYMBOL
This item is made in conformity with all the applicable European directives
Class II appliance

TECHNICAL FEATURES

- Stainless steel fixed blade
- Stainless steel moving blade
- 8 Blade adjustment (0,8mm-12mm)
- Cord/Cordless operation
- Ni-MH battery
- Moving cutting set
- ON/OFF switch
12

Publicité

Table des Matières
loading

Table des Matières