Belkin CarAudio Connect FM Mode D'emploi page 6

InITIAL seTUp
sections
table of contents
3� Store that frequency in memory by pressing and holding one of the
two MEM buttons. When the frequency is stored successfully, the
product will beep and MEMORY 1 or MEMORY 2 will show on the
display.
CarAudio Connect FM LineCast Auto FM
1
or
2 3
4� Turn on your car stereo and set the input source to FM.
5� Tune your car stereo so that its FM frequency matches the
CarAudio Connect FM.
6� If possible, store the frequency in one of your car stereo's preset
buttons. Typically this is done by pressing and holding the chosen
preset button until the stereo beeps or gives some indication that
the frequency has been stored.
7�
Insert the product's audio cable into the headphone jack of your
phone.
*If you hear static as you travel from one part of town to another,
press the Clearscan button again to find a better frequency�
3. Store that frequency in memory by pressing and holding one of the
two MEM buttons. When the frequency is stored successfully, the
product will beep and MEMORY 1 or MEMORY 2 will show on the
display.
4
4 5
3. Store tha
two MEM
product
display.
6
4. Turn on y
5. Tune you
Auto FM
6. If possib
buttons.
preset b
the frequ
*If you hear sta