Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Touch Pad Control Panel (Fig. 4)
The heat gun gives you a wide temperature range to choose from,
depending upon the type of project. These can be controlled via the
Control Panel.
1) Power button: Turns
the heat gun ON and
OFF or switches the
heat tool into cool
down mode
2) Mode selector:
Changes the fan speed
in which you are
operating
3) Air flow icon
4) Air flow indicator. Fills
from right to left
5) Text/number display
6) Temperature icon
7) Temperature indicator.
Fills from left to right
8) Temperature selector: Increases the temperature (+)
9) Temperature selector: Decreases the temperature (-)
Screen currently shows default start-up display. 650
4
1
4
5
6
9
o
F at highest fan speed.
Cool down Mode (Fig. 5)
While the heat gun is
operating, press the power
button once to enter cool
down mode. When cool down
mode is entered, the gun
will run for 3 minutes with
maximum air flow. During this
period, the temperature bars
2
will all flash and step down to
indicate cooling. To override
cool down mode, press and
3
hold the power button for 2-3s.
7
Startup
1. Plug the unit into a standard wall outlet.
2. Turn on the heat gun by pressing the POWer button on the touch
8
pad (Fig. 4, 1). When the gun is turned on, it is automatically set to
the default temperature of 650ºF as shown in Fig. 4.
3. Use the plus and minus buttons (Fig. 4, #8 & #9) to adjust the
temperature. Single press to increase temperature in ten degree
increments. Hold to increase more quickly.
4. As the temperature is increased, bars will flash to indicate that the
gun is coming up to temperature. As the higher temperature is
reached, the bars turn solid.
5 As the temperature is decreased, bars will flash to indicate that
the gun is still at a high temperature. As the lower temperature is
reached, the bars turn off.
IMPOrTaNT: If the blower motor in the heat gun does not turn
on when the POWer button is activated, turn the switch OFF
immediately. The heating element will burn out if it is not cooled by
the blower.
5
7
EN
Publicité
Table des Matières
