WAGNER FURNO 700 Guide D'utilisation page 3

Read all safety information before operating the equipment. Save theSe InStRuctIonS.
a double plastic bag, close it with tape or twist ties and dispose of
properly.
• Remove protective clothing and work shoes in the work area to
avoid carrying dust into the rest of the building. Wash work clothes
separately. Wipe shoes off with a wet rag and then wash it with the
work clothes. Wash hair and body thoroughly with soap and water.
Hazard: eXPLOSION Or FIre
This heat gun produces extremely high temperatures (as
high as 1300º F). It must be used with caution to prevent
combustible material from igniting.
PreveNTION:
• Keep the gun in constant motion. Do not stop or dwell in one spot.
• Use extreme caution if the
other side of the material being
scraped is inaccessible, such
as house siding. Hidden areas
such as behind walls, ceilings,
floors, soffit boards and other
panels may contain flammable
materials that could be ignited
by the heat gun when working
in these locations. The ignition
of these materials may not be
readily apparent and could result in property damage and injury
to persons. When working in these locations, keep the heat gun
moving in a back-and-forth motion. Lingering or pausing in one
spot could ignite the panel or the material behind it.
• Do not use near surfaces with cracks or near metal pipes or
flashing. Heat may be conducted behind the work surface and
Important Safety Information
Fascia
So t
Inside
Wall
Siding
Save theSe InStRuctIonS
ignite hidden material. The ignition of hidden materials may not
be readily apparent and can result in property damage and injury.
• Do not use electric tools in the presence of flammable liquids or gases.
• Do not use near combustible materials such as dry grass, leaves,
and paper which can scorch and catch fire.
• The nozzle becomes very hot. Do not lay the heat gun on
flammable surfaces when operating the gun or immediately after
shutting the gun off. Always set the gun on a flat, level surface
so that the nozzle tip is directed upwards and away from the
supporting surface.
• Do not touch the nozzle until the tool has cooled.
• Do not use the heat gun as a hair dryer.
• Tools and paint scrapings become very hot. To avoid burns, use work
gloves when scraping.
• Always treat the hot air units with the same respect as an open flame.
• A fire may result if the appliance is not used with care, therefore:
– be careful when using the appliance in places where there are
combustible materials;
– do not apply to the same place for a long time;
– do not use in presence of an explosive atmosphere;
– be aware that heat may be conducted to combustible materials
that are out of sight;
– place the appliance on its stand after use and allow it to cool
down before storage;
– do not leave the appliance unattended when it is switched on.
3
EN