CyberPower CPS7500PRO Manuel D'utilisation page 2

Safety and EMC instruction
This manual contains important safety instructions. Please read and follow all instructions carefully during
installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or
operate your Emergency Power System (EPS).
CAUTION!
To prevent the risk of fire or electric shock, install in a temperature and humidity
controlled indoor area free of conductive contaminants. (Please see specifications for acceptable
temperature and humidity range).
CAUTION!
To reduce the risk of electric shock, do not remove the cover.
CAUTION!
EPS must be connected to an AC power outlet with circuit breaker protection. Do not
plug into an outlet that is not grounded. If you need to de-energize this equipment, turn off and unplug the
unit.
CAUTION!
To avoid electrical shock, turn off the unit and unplug it from the AC power source before
servicing EPS, replacing the external battery or installing equipment.
CAUTION!
To reduce the risk of fire, only connect the EPS to a circuit with 70 amperes
Series) maximum branch circuit over-current protection in accordance with the CE requirement.
CPS7500PIE Series include CPS7500PIE
CPS7500PRO Series include CPS7500PRO
CAUTION!
The building wiring socket outlet (shockproof socket outlet) must be easily accessible and
close to the EPS.
CAUTION!
Please use only VDE-tested, CE-marked mains cable (e.g. the mains cable of your
equipment) to connect the EPS to the building wiring socket outlet (shockproof socket outlet).
CAUTION!
Please use only VDE-tested, CE-marked power cables to connect the loads to the EPS.
CAUTION!
When installing the equipment, ensure that the sum of the leakage current of the EPS and
the connected equipment does not exceed 3.5mA.
CAUTION!
This is permanently connected equipment and only qualified maintenance personnel may
carry out installations.
CAUTION!
Do not disconnect the mains cable on the EPS or the building wiring socket outlet
(shockproof socket outlet) during operations since this would remove the protective ground of the EPS
and of all connected loads.
CAUTION!
THE EPS shall be connected to the emergency switching device.
DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT!
any circumstance that would affect operation or safety of any life support equipment or with any medical
1
SAFETY AND EMC INSTRUCTIONS
C PS7500PIE-FR
、
C PS7500PRO-FR
、
Copyright © 2011 CyberPower Systems, Inc.
CPS7500PRO/CPS7500PIE
C PS7500PIE-UK and other versions.
、
C PS7500PRO-UK and other versions.
、
(CPS7500
DO NOT use in