Beurer Velvet Skin Pro Mode D'emploi page 36

7. Place the device on the skin at a 90 degree angle so that the attachment is in complete contact.
The integrated skin contact sensor prevents light pulses being accidentally emitted without skin
contact.
8. The indicator lamp on the rear of the device illuminates green in order to indicate that you can conti-
nue with the treatment.
9. Press the trigger button to emit a light pulse.
10. The device is equipped with an "Auto Flash" mode. This mode is activated if you hold the trigger
button down for 3 consecutive light pulses. The device now automatically emits light pulses without
having to press the trigger button again, as long as there is sufficient skin contact.
Note
If you press the trigger button and your skin is too dark or too tanned, the indicator lamp on the device
illuminates red. In this case, the device does not trigger a pulse on this area of skin.
If the device does not have sufficient contact with the skin and you press the trigger button, the indi-
cator lamp on the device illuminates orange. In this case, the device does not trigger a pulse on this
area of skin either.
WARNING
Do not treat the same area of skin more than once per hair removal session!
Treating an area of skin more than once during a single hair removal session can increase the
probability of side effects.
Try to avoid overlapping pulses.
Note
The pulses from the beurer Velvet Skin Pro should be applied in rows – beginning at one end of each
row, continuing to the other end. This technique allows better monitoring of the areas of skin that
have already been treated and helps you to avoid treating the same area more than once or treating
overlapping areas of skin. The light area of the beurer Velvet Skin Pro is designed in such a way that
it leaves a temporary impression on the treated area of skin. These visible impressions can be used
for precise placement of the next pulse.
11. Lift the device off the skin and place it on the next part of the treatment area. When repositioning,
make sure not to leave any gaps or overlap the treated skin. The device recharges itself immediately
and is ready for the next pulse within max. 3 seconds (at the highest intensity level) (the indicator
lamp on the device continuously illuminates green once again). Repeat the process until the entire
area of skin has been treated.
After treatment with beurer Velvet Skin Pro
• Once the hair removal session using the beurer Velvet Skin Pro is finished, switch off the device by
pressing the ON/OFF button.
• After each hair removal session, it is recommended that you clean your beurer Velvet Skin Pro device,
paying particular attention to the light area (see Chapter 9.1 "Cleaning the beurer Velvet Skin Pro").
• After cleaning, it is recommended that you store your beurer Velvet Skin Pro device in its original box
and keep it away from water.
36