Toa WT-D5800 Mode D'emploi page 15

step 7.
M
After confirming that the WT-D5800's LCD
display has switched to the "SUCCESS"
indication, release the microphone's
Encryption setting switch.
step 8.
r Release the Set key.
The LCD display returns to the "EXIT"
indication.
step 9.
M
Confirm that the microphone's Encryption
indicator is lit.
The encryption setting is now ON.
M step 10.
Switch off the microphone.
step 11.
r
Press the Set key. Then, the display returns to the "PAIRING" indication.
step 12.
When any other setting is not needed, select "EXIT" with the Up or Down key and
r
press the Set key.
The unit returns to the normal operating state.
Note
When another setting is needed, select the necessary setting item with the Up or
Down key and press the Set key.
Notes
• Do not switch OFF the power to the microphone or receiver during setting.
• Hold down the microphone's Encryption setting switch and the receiver's Set key until the
"SUCCESS" indication appears on the receiver's LCD screen.
If the microphone's Encryption setting switch or the receiver's Set key is released while the
"RECEIVING" indication is displayed on the receiver's screen, the receiver will not have correctly
received the new ID number, leaving the ID number unchanged from the previous value. To match
the receiver ID number with the microphone ID number, switch OFF the microphone's encryption
setting, then repeat steps 1 – 11 above.
Tips
• The ID number is updated when the encryption is switched from OFF to ON again. (The encryption
ON/OFF status and ID number are retained even if the power switch is switched OFF.)
• Settings can be performed regardless of whether the microphone or receiver Encryption setting
switch was depressed first.
• The receiver does not output audio during ID number setting, even if it receives a radio signal from
the microphone.
WT-D5800's LCD screen
P A I R I N G P R O C E S S
S U C C E S S
WM-D5200
Release
Lit
7
15