Installation And Connection - VOSS.farming impuls duo Série Notice D'utilisation

6. INSTALLATION AND CONNECTION

Install the energiser vertically on a wall. You can use the included screws for this. A
practical clip-mount bracket (Art: 41150) is also available as a separate accessory. Two
clips are required for installing the VOSS.farming impuls duo series. This lets you install
the energiser on a conventional DIN rail.
The VOSS.farming impuls duo can withstand all weather conditions such as rain, splash
water, sunshine, high temperatures and frost. However, we recommend that you place
the VOSS.farming impuls duo somewhere that offers protection against the weather,
such as a house wall, (roofed) shelter, stable, box or in an enclosed space such as a
garage, summer house, carport, shed or workshop.
NOTE: Energiser impuls DUO DV 160 / DV 160 RF may only be operated under voltage not
exceeding 16 volts. Therefore, only use the adapter included within the contents of delivery
or a commercially available 12V electric fence battery with the device. The device must not
be connected directly to a solar panel. It is essential to use a suitable controller for this
purpose. Avoid ground contact with battery cable to prevent damage to the unit.
TIP: Before you connect the VOSS.farming impuls duo to your fence, you can test the
energiser. Unscrew the two terminal nuts (6 and 7) and connect the device to a power
source. The control LED (3) will light up, depending on the selected operational mode,
and the LED bar (4) will flash simultaneously with each released impulse.
For further inspection, you require a screwdriver long enough to create a connection
between the terminals. Hold the screwdriver by the insulated handle. CAUTION: Holding
the screwdriver by the shaft or by the damaged or non-insulated handle will result in a
shock.
Now place the shaft on one of the terminals and start pushing it in the direction of the
34
41405 | 12 | 2020 | V2