Standard Equipment; Accessories - EUROMACH R 1253 Forester Mode D'emploi

•
Front window tilts inside (no external overhang).
The operator's seat can be adjusted and is constructed in order to minimize the vibrations. The
seat is equipped with safety belt and headrest
The board panel is equipped with an inboard computer that allows to control all the data of the
machine and of the engine.
The cabin is equipped with heating system and air conditioner inside the cab (option), no
projection over the cabin.
Controls
The working functions are controlled through 2 joysticks, located on the two sides of the seat,
and 3 foot pedals.
All boom functions (including bucket and additional accessory), rotation and traction can be
feathered. The under carriage functions are of the on/off type and are executed through 3
mini-joysticks installed in each joystick.
The working functions are activated when the micro switch located on the left armrest is
activated, the system is activated when the armrest is lowered in working position.
The steering function is activated by the mini joysticks installed on the joystick itself.
Various
•
The most stressed parts of the excavator are made out of high strength steel.
(minimum warranted yielding load equal to 700 – 900 N/mm2).
•
Buckets and legs are made out of special steel that has a high resistance against
wearing.
•
The pins are made out of tempered 38CrNiMo4 steel and case-hardened 16CrNi4 steel.
Maximum strength and resistance against wearing.
•
The cylinders piston roads are made out of induction hardened and tempered 42CrMo4
steel successively chromed. The procedure warrants a considerable strength of the
cylinders and a surface resistance against shocks.

Standard equipment

•
Mechanical and hydraulic provision for the assembly of a winch on the chassis (the
winch can be provided as option).
•
Locking valves on 1st and 2nd cylinders (ISO standards 8643), a acoustic buzzer is
installed standard on the excavators together with the valves; it informs the operator
when the maximum capacity is reached.
•
Hydraulic provision for revolving bucket und hydraulic hammer.
•
Hydraulic provision for an accessory to be mounted on the boom
•
Excavating bucket cm 60

Accessories

Here below a list of the accessories and options that can be installed on the excavator:
•
The excavator can be supplied with buckets of various dimensions, all of them made out
off high resistance steel, a list follows:
Excavating bucket
o
Rock bucket
o
Channels cleaning bucket
o
Revolving channels cleaning bucket
o
•
The excavator can be equipped with a hydraulic activation for additional equipments
that can be installed on the boom tip. (The equipment can be supplied directly by
EUROMACH)
Bush cutter machine
o
Power tilt
o
Edizione 01/16 – Revisione 00
Technical Specifications – R1253
R1253
Feb 16
UT
T
10