Care And Maintenance - Klarstein 10031907 Mode D'emploi

EN
Ions function
Press the Ions button after startup or in other modes, the indicator will light while anion
generator releasing anions. Press the Ions button again the indicator will light out and
the anion generator stop releasing anions.
UV Lamp function
Press the UV button after startup or in other modes, the indicator will light while the UV
LED light. Press the UV button again, stop this function.
Stop function
If you want to switch off the air purifier completely press the [Power] button, the unit will
switch off and all light will be off.
PM2.5 Indicator function
After start up, the PM2.5 Indicator will glow twinkle, 30 seconds later, it will show
the indication of PM2.5 detected by sensor. Notice: This function cannot be used as
Professional instrument
Filters reset button function
Press this button when start up , the button lamp light, and the display will show the
Residual life of filters „%". 3 seconds later ,it will turn back. When the filters needed
to changed, the button Lamp glow twinkle . After replace filters, Press this button for 5
seconds to reset.

CARE AND MAINTENANCE

Before attempting to perform any maintenance on the air purifier, disconnect the
power adapter!
Filter
• Suggested time of changing filter: about once a year.
• It depends on different places and usages. For example, changing time of filter may
be shorter in contaminated zones or smoking areas, etc.
• Please change the filter if the purification effect is not good.
16