Setup / First Use; Display Indicators - SilverCrest SSE 6 C3 Mode D'emploi

Setup / first use

1) Place the appliance on a suitable, level surface .
2) Open the lid 2 .
3) Pull the plug 1 from the refill opening q .
4) Pour liquid soap into the soap tank .
note
► During filling, note the "Max" mark that is visible, if you look into the
soap tank . Never exceed the "Max" mark when filling with soap!
Otherwise, the appliance may overflow .
► Pour in at least 70 ml of soap; otherwise, the "Fill level" indicator e will
flash .
5) Replace the plug 1 in the filling opening .
6) Remove the protective film from the display 8 and close the lid 2 .
The appliance is now ready for use .

Display indicators

note
► The display indicators are only visible if the lid is open .
■ The "Soap quantity" indicator w shows the amount of soap
dispensed for each use .
■ The "Fill level" indicator e shows how much soap remains in the
soap tank .
The fewer bars are visible, the less soap there is in the soap tank .
If only one bar remains in the fill level, the "Fill level" indicator e
begins to flash . Refill the soap tank .
■ The "Battery" indicator r shows the charge level of the batteries
that have been inserted . If only one bar remains in the "Battery"
indicator r, you should replace the batteries soon .
■ 18 │
GB│IE
SSE 6 C3