Camplux BW Série Manuel D'utilisation Et D'entretien page 18

1
17
● Place at a comfortable height without putting stress on the gas hose. If the unit
is to be permanently mounted, use screws to attach the bottom tab firmly.
● Before opening LP cylinder valve, check the coupling nut for tightness. When
appliance is not in use, turn off LP cylinder valve on supply cylinder.
● Never use LP cylinder if visibly rusted, damaged or out of date.
● Clean and inspect the hose before each use of the appliance. If there is
evidence of abrasion, wear, cuts or leaks, the hose must be replaced prior to
the appliance being put into operation.
WARNING: THE PORTABLE TANKLESS WATER HEATER IS CAPABLE
OF PRODUCING SCALDING WATER TEMPERATURES!
Connecting, Disconnecting From Gas
Cylinder And Storage
This appliance shall only be connected to a 20lb (Size 1: ∅12 5/16" *H17 5/16";
Size 2: ∅11 13/16" *H17 7/16") cylinder with a POL cylinder valve certified to
CAN/CSA-B339. The LP-gas cylinder(s) must be constructed and marked in
accordance with the specifications for Cylinders, Spheres, and Tubes for the
Transportation of Dangers Goods, CSA B339.
Please always use cylinder at upright position for vapor withdrawal. Connect
certified gas regulator QCC-1 with LP gas supply cylinder by hand, regulator hose
connect with appliance in gas inlet fitting by wrench.
Connecting to cylinder:
Connect the gas regulator to
the gas cylinder,tightening using
two fingers support posts.
3330-A Marathon Ct Charleston, SC 29418
Visit Us: Camplux.com
Disconnecting from cylinder:
Disconnect the gas regulator
from the gas cylinder,tightening
using two fingers support posts.
+1(844) 538-7475
support@camplux.com