Dexter Laundry T-20X2 Mode D'emploi page 30

Usage Menu:
The Usage menu allows for the user to track data about machine usage. See below for detailed information on
each sub menu option.
1. "Coin Audit": The coin audit field shows the accumulation of coin pulses that were sent to the control
over each of the left and right coin inputs. Note that this is a count of coin pulses, not an accumulated
report of vend value.
a. The user can also return the coin audit amounts to the factory default setting (zero). To reset all
coin audit values, press "Enter" when the "DEFAULT" prompt is shown. Press "Enter" again when
the "RESET" prompt is shown to confirm the action.
2. "Motor Hours": The motor hours field shows the accumulated hours of operation for both the upper and
lower motors independently. In many cases, it will match the cycle hours of the machine. However,
separate fields are provided in the event that a motor is replaced on a machine. The user can set the
motor hours to a designated number. For example, if it is necessary to replace the control on a machine,
the new control could be programmed to show the motor hours that were recorded by the previously
installed control. The individual digits of the hours count can be set by using the "Up" or "Down" buttons
to change the number that is flashing. Once the desired digit of the hours is chosen, press the "Enter"
button to move to the next digit. Once the complete hours are chosen, the "Enter" button must be held
down for 3 seconds to confirm the action.
a. The user can also return the motor hours to the factory default setting (zero). To reset the motor
hours, press "Enter" when the "DEFAULT" prompt is shown. Press "Enter" again when the
"RESET" prompt is shown to confirm the action.
3. "Cycle Hours": The cycle hours field shows the accumulated hours of operation for both the upper and
lower dryer dryers independently. In many cases, it will match the motor hours of the machine. However,
separate fields are provided in the event that a motor is replaced on a machine. See the Motor Hours
description for more information.
The figure below shows the sub menu options for Usage:
8514-253-001 REV L page 30