Dexter Laundry T-20X2 Mode D'emploi page 22

When manual programming mode is entered, the "Start", "High", "Medium" and "Low" buttons for the lower
dryer perform alternate functions. Please note that the changes made using the lower dryer buttons affect both
upper and lower dryers.
Button Name Alternate Function in Programming Mode
Becomes the action to accept the displayed option or the "Enter"
Start
key
Becomes the action to move UP through displayed options (Press
High
& hold for accelerated scrolling)
Becomes the action to move DOWN through displayed options
Medium
(Press & hold for accelerated scrolling)
Becomes the action to move back a step (1 press) or EXIT from
Low
programming mode (press for 3 seconds)
These alternate functions allow the user to move through a menu of options to choose various programmable
settings. The figure below shows the top level menu. Choosing an option from the top level menu will then
display the next level of options (the sub menu).
Quick Test Option:
When the Quick Test Option is chosen, the dryer will begin a shortened dry cycle without the displayed vend
price being met. The purpose of this shortened cycle is to test all major components for proper operation.
Error Codes should all function normally during this test. The display will show customer prompts in a similar way
to a normal dry cycle.
Continuous Test Option:
Similar to the Quick Test, when the Continuous Test Option is chosen, the dryer will begin a dry cycle without the
displayed vend price being met. However, in this case, it will be a continuously-running cycle. It will not time out
after any designated amount of time.
CAUTION: This option is meant for factory use only. Do not operate the dryer with this cycle active without
factory authorization.
8514-253-001 REV L page 22