Dexter Laundry T-20X2 Mode D'emploi page 29

10. "Date": Similar to "Time", if a problem occurs and the RTC date is not accurate, it can be reset to the
current date using this option.
a. The day of the month in "DATE" can be set by using the "Up" or "Down" buttons to change the
number that is flashing. Once the desired day of the month is chosen, press the "Enter" button to
move to the month of the year. Once the desired month of the year is chosen, press the "Enter"
button to move to the year. Once the day, month and year are all chosen, the "Enter" button
must be held down for 3 seconds to confirm that RTC is meant to be reset to the complete entry.
11. "Out of Service" – The control can be put into an Out-of-Service mode via manual programming. When
the mode is "ON", the control will scroll "OUT OF SERVICE" on the display. The machine will not react to
any vend input and will not operate when in this mode. The factory default is "OFF".
To reset all values in the Settings options to factory default, press "Enter" when the "DEFAULT" prompt is shown.
Press "Enter" again when the "RESET" prompt is shown to confirm the action.
The figure below shows the sub menu options for Settings:
8514-253-001 REV L page 29