ASROCK K10N7SLI Mode D'emploi page 24

eSATAII Connector
(eSATAII_TOP: see p.2, No. 37)
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA
HDD power connector
USB 2.0 Headers
(9-pin USB8_9)
(see p.2 No. 18)
(9-pin USB6_7)
(see p.2 No. 19)
Infrared Module Header
(5-pin IR1)
(see p.2 No. 26)
2 4 2 4 2 4
2 4 2 4
connect to
the power
supply
ASRock K10N7SLI Motherboard
This eSATAII connector
supports SATA data cable for
external SATAII function. The
current eSATAII interface
allows up to 3.0 Gb/s data
transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
You can also use the SATA data
cable to connect SATAII_6
(PORT5) connector and eSATAII
connector.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
power cable to the power
connector of the power supply.
Besides six default USB 2.0
ports on the I/O panel, there are
two USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
This header supports an
optional wireless transmitting
and receiving infrared module.