Drains Connection; Detergent Dispenser Connection (Optional); Water Softener Connection (Optional); Booster Pump (Optional) - AFG ACO1000 Manuel D'installation, Utilisation Et Entretien

in force in the country in which the
appliance is installed.
Never cut off the water supply whilst
the appliance is operating.
Should a machine be replaced with a
new one, for the connection to the
water supply mains, the new fittings
supplied with the machine shall have
to be employed to replace existing
fittings.
Identify the supply pipe and follow this procedure:
insert the seal washers into the two
threaded nuts of the water supply pipe;
screw on a threaded nut at the solenoid val-
ve outlet located at the rear of the appliance
without overtightening to prevent the risk of
breakage of the joints;
tighten the other threaded nut on the water
supply stopcock.

DRAINS CONNECTION:

To connect the discharge pipe ensure that it is
connected in an open trap.
Connect the waste pipe onto the elbow
located underneith the machine by applying
moderate manual pressure. The above 2m
waste pipe is also supplied with the machine.

DETERGENT DISPENSER CONNECTION (Optional):

When required, the machine can be supplied
with built in electric detergent dispenser.
In the event of the doser being required after
machine purchase, only have this installed by
"professional personnel" or "technical staff of
the nearest after-sales centre".
Doser installation requires:
Electrical connection: connect the power wires
of the detergent dispenser in parallel with the power
wires of the machine control solenoid valve.
Water connection: Cut the supplied tube in
two parts. Fit the filter and the weight in one
end of the suction tube and connect the other
end to the inlet connection of the detergent
pump. Fit the detergent injector in the hole in
the tank. Connect the second tube between
the outlet connection of the detergent pump
and the injector. Put the tube with the filter
and the weight into the detergent bin.

WATER SOFTENER CONNECTION (Optional):

To ensure the long life of your machine, only
use "soft water" for washing. Get to know the
hardness of your water supply (contact your
town council or drinking water utility).
It is important that an 8 or 12 L water softener,
for glasswashers, and 16 or 20 L water softener,
for dishwashers is installed with the machine to
achieve maximum washing power, (contact the
Service Department).
BOOSTER PUMP (Optional) (Fig. 1):
In the event of the water supply pressure being
below 0.2 MPa (2 bar), it is best to fit an auxiliary
pump to increase the pressure. At the time of
ordering, depending on the model, the machine
can be supplied complete with a booster pump.
Should the dishwasher not be used for long
periods, check that the rinse booster pump turns
freely. This is done by turning a screwdriver in
the appropriate slot in the motor shaft (fan side).
Should it be jammed, hit the end of the screwdriver
lightly with a plastic hammer.
21
ENGLISH
Fig. 1