Location Of Controls - AEG FT 4925 Mode D'emploi

English
74
• When the environment changes a lot (for instance, from indoor to out-
door), please wait in the new environment for about 30 minutes before
measuring the new temperature.
• The intervals shall be 10 seconds when constant measurement are
made. It is normal that there are deviations in constant measurement
between short intervals, in which case the average reading can be taken
as the result.
• There is no absolutely standard value of body temperature. For healthy
persons the temperature can fluctuate between 0.2 ~ 1°C (32.36 ~
33.8°F) in different areas of the body. Always measure the body tem-
perature at the same time of the day.
• When the environmental temperature exceeds the functional tempera-
ture range of the device, the device will show "Err" symbol.
• When the temperature of the measured is lower than 32°C, "Lo" symbol
will be displayed on the screen; when the temperature of the measured
is higher than 42.9°C, "Hi" symbol will be displayed on the screen.

Location of Controls

1 Power / Scan button
2 Display
3 Front cover / Attachment for forehead measurement
4 Stand
5 Probe
6 Battery compartment
7 Time set button