Abus HSRM20000 Manuel Utilisateur page 30

the device is working properly and can be fastened. The test signal (3 beeps) sounds
4 times in total and the integrated LED flashes too.
Alternatively, you can use the RM0010 test spray available from ABUS to test the
wireless smoke detector. If the RM0010 test spray enters the detection chamber, an
alarm should sound, so that you can test whether the wireless smoke detector is
working properly.
If you have connected the smoke detectors in a network for the first time, wait 10
minutes before testing so that the detectors can exchange sufficient data packets to
guarantee that they will operate correctly.
Networking the wireless smoke detectors
Please note: do not network another model of wireless smoke detector with
this one. This may lead to improper functioning and it cannot be guaranteed
that the device will operate problem-free.
If the test mode on one detector in a network is activated, all other networked
detectors will produce a signal too.
If one of the detectors in the network detects an alarm, all other detectors in
the network will raise the alarm.
If the battery in one detector is low, this will be indicated directly by the affected
detector. In addition, this will also be indicated by all networked detectors every
4 hours by 2 beeps and a flashing LED.
Networking the detectors:
You will require at least two wireless smoke detectors to be able to create a wireless
detector network. A maximum of 32 detectors can be networked. Due to the network
10