Network Setup; Configuring Your Network Connection - Samsung HT-J4500 Guide D'utilisation

Network Setup

When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.

Configuring Your Network Connection

If you skipped network setup during the Initial Setup,
follow the instructions below to configure the home
theater's network connection.
Before you begin, contact your ISP to find out if your
IP address is static or dynamic. If it is dynamic, we
recommend you use the automatic procedure below.
If it is static, you must use the manual procedure that
follows.
• Before you begin, confirm that the product is
connected to your router with a network cable.
K
Automatic
To start the configuration process, follow these steps:
1. In the Home menu, select Settings, and then
press the E button.
Select Network, and then press the E button.
2.
3. Select Wired Network Settings, and then press
the E button.
The Wired Network Settings screen appears.
Press the + button on the Internet Protocol
4.
Setup menu.
Use $% button to select Auto, and then press
the E button.
Settings
Wired Network Settings
Picture
Sound
Internet Protocol Setup
Network
IP Address
System Subnet Mask
Gateway
Language
Security
DNS
General DNS Server
Support
: Auto
0 0 0 0
:
:
0 0 0 0
:
0 0 0 0
: Auto
:
0 0 0 0
> Move " Select ' Return
19
- English
5. The Network function acquires and fills in the
values for IP Address, Subnet Mask, etc.,
automatically.
6. After the Network function has acquired the
network values, press the
Select Network Test, and then press E . The
7.
home theater validates the network connection.
When it is done, press the
K
Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the Network
Settings values manually. You can get the Network
Settings from your Internet Service Provider (ISP).
Settings
Wired Network Settings
Picture
Sound
Internet Protocol Setup
Network
IP Address
System Subnet Mask
Gateway
Language
Security
DNS
General DNS Server
Support
1. Follow the first four steps in the Automatic
procedure, but select Manual instead of Auto in
Step 4.
▼
2. Press the button to go to the first entry field (IP
Address).
3. Use the number buttons on your remote to enter
numbers.
4. When done with each field, use the ► button to
move successively to the next field.
You can also use the other arrow buttons to
move up, down, and back.
5. Enter the IP Address, Subnet Mask, and
Gateway values.
6. Press the ▼ button to go to DNS.
7. Press the ▼ button to go to the first DNS entry
field. Enter the numbers as above.
8. Press the RETURN button on your remote.
RETURN button.
RETURN button.
: Manual
: 0 0 0 0
:
255 255 255 0
:
0 0 0 0
: Manual
:
0 0 0 0
> Move " Select ' Return