Upright XRT Electric Guide De L'opérateur page 5

26. Turn the Lift/Drive Switch to DRIVE.
27. Engage the Interlock Switch and slowly
28. Push the Steering Switch RIGHT, then
29. Turn the Lift/Drive Switch to LIFT.
30. Engage the Interlock Switch and slowly
31. Pull back on the Control Handle. The plat-
32. Lower the platform completely.
33. Push the Platform Emergency Stop button
34. Turn the Platform Controls key switch to
35. Push the Platform Emergency Stop button
36. Dismount the platform.
37. Push the Chassis Emergency Stop button to
XRT Electric
NOTE: The Speed Range Selector Switch
has two positions: HIGH SPEED and
LOW SPEED. Perform Step 27 for each
speed.
push the Control Handle FORWARD, then
REVERSE, to check for proportional speed
control.
LEFT, to check for steering control.
push the Control Handle forward to check
the platform lift controls. Raise the platform
to full elevation.
form should descend and the Audible Low-
ering Alarm should sound.
to check for proper operation. All the
machine functions should be disabled. Pull
out the Platform Emergency Stop button to
resume.
OFF.
to the OFF position.
the OFF position.
Figure 3: Platform Controls
STEERING SWITCH
SPEED SELECTOR
INTERLOCK SWITCH
LOW
BATTERY
RAISE FWD.
EMERGENCY
LOWER REV.
STOP
EMERGENCY STOP
CONTROL HANDLE
MOTOR
TEMPERATURE
HIGH LOW
SPEED SPEED
LIFT DRIVE
LIFT/DRIVE
KEY SWITCH
5