Upright XRT Electric Guide De L'opérateur page 3

I
NTRODUCTION
P -O
RE PERATION AND
XRT Electric
This manual covers the XRT Self-Propelled Electric Work Platforms. This machine operates on a
48 volt battery powered system. This manual must be stored on the machine at all times.
S I
AFETY NSPECTION
Carefully read, understand and follow all safety rules, operating instructions, labels, and the Scaf-
fold Industry Association's MANUAL OF RESPONSIBILITIES. Perform the following steps each
day before use.
1. Open module covers and inspect for damage, oil leaks or missing parts.
2. Check the hydraulic oil level sight gauge on the hydraulic tank with the platform fully lowered.
Add hydraulic oil if necessary.
3. Check that fluid level in the batteries is correct (see "Battery Maintenance" on page 13).
4. Check that all guardrails are in place with all fasteners properly tightened.
5. Check that the slide-out deck extension is secured with the pin.
6. Check tires for damage.
7. Inspect the machine thoroughly for cracked welds, loose or missing hardware, hydraulic
leaks, damaged control cable, loose wire connections and wheel bolts.
8. Close and secure module covers.
9. Move the machine, if necessary, to an unobstructed area to allow for full elevation.
10. Pull the Chassis Emergency Stop Switch to the ON position.
11. Pull the Platform Emergency Stop Switch to the ON position.
12. Turn the Platform Controls Key Switch
clockwise to ON.
13. Use the Chassis Controls for steps 14
through 20.
14. Turn the Platform/Chassis/Brake Release
Switch to CHASSIS.
15. Push the Chassis Controls RAISE button
to elevate the platform until the Scissor
Brace can be rotated to the vertical posi-
tion. Block the elevating assembly as
described on page 12.
16. Visually inspect the elevating assembly,
lift cylinder, cables and hoses for damage
or erratic operation. Check for missing or
loose parts.
17. Remove the Scissor Brace as described
on page 12.
18. Push the Chassis Controls RAISE button to fully elevate the platform.
19. Lower the platform partially by pushing in on the Chassis Controls LOWER button, and check
operation of the audible lowering alarm.
20. Push the Chassis Emergency Stop button to check for proper operation. All the machine func-
tions should be disabled. Pull out the Emergency Stop button to resume.
Figure 1: Chassis Controls
PLATFORM/CHASSIS/BRAKE RELEASE
EMERGENCY STOP
RAISE
LOWER
BRAKE RELEASE
3