Blackstone 1565 Guide Du Propriétaire page 10

WARNING
!
Turn controls and gas source or tank
OFF when not in use.
CAUTION
!
If ignition does NOT occur in 5 seconds,
turn the burner controls OFF, wait 5 min-
utes and repeat the lighting procedure.
If the burner does not ignite with the
valve open, gas will continue to flow out
of the burner and could accidently ignite
with risk of injury.
Burner Flame Check
•
Light the burners and rotate the knobs from high to
low. You should see a smaller flame in low position
than seen on high. Perform burner flame check by
looking below the griddle top on the side of the unit
to view the burners below (as seen in the image
above). Always check the flame before each use.
If there is a sudden drop or low flame issue, please
refer to our troubleshooting section.
Turning Grill Off
•
Turn all knobs to the OFF position. Turn LP
cylinder OFF by turning hand-wheel clockwise
to a full stop.
Ignitor Check
•
Turn gas off at LP cylinder. Press and hold elec-
tronic ignitor button. "Click" should be heard and
spark seen each time between each collector box
or burner and electrode. See "Troubleshooting" if
no click or spark
10
www.blackstoneproducts.com
!
•
Important: Make sure gas is off at LP cylin-
der before checking valves. Knobs lock in OFF
position. To check valves, first push in knobs
and release, knobs should spring back. If knobs
do not spring back, replace valve assembly
before using griddle. Turn knobs to low position
!
then turn back to OFF position. Valves should turn
smoothly.
•
Before each use, check to see if hoses are
cut or worn. Replace damaged hoses be-
fore using griddle. Use only identical replace-
ment part valve/hose/regulator as specified
in the Parts List of this Use and Care Guide.
General Griddle Cleaning
•
Do not mistake brown or black accumulation of
grease and smoke for paint. Apply a strong solution
of detergent and water or use a griddle cleaner with
scrub brush on insides of the griddle and bottom.
Rinse and allow to completely air dry. Do not apply
a caustic griddle/oven cleaner to painted surfaces.
•
Plastic parts: Wash with warm soapy water and wipe
dry. Do not use Citrisol, abrasive cleaners, degreas-
ers or a concentrated griddle cleaner on plastic
parts. Damage to and failure of parts can result.
•
Painted surfaces: Wash with mild detergent
or nonabrasive cleaner and warm soapy wa-
ter. Wipe dry with a soft nonabrasive cloth.
•
Stainless steel surfaces: To maintain your
griddle's high quality appearance, wash with
mild detergent and warm soapy water and
wipe dry with a soft cloth after each use.
•
Baked-on grease deposits may require the use
of an abrasive plastic cleaning pad. Use only
in direction of brushed finish to avoid damage.
Do not use abrasive pad on areas with graphics.
•
Cooking surfaces: If a bristle brush is used to
clean any of the griddle cooking surfaces, ensure
no loose bristles remain on cooking surfaces prior
to grilling.
Valve Check
Hose Check