TECO 40 TOP Manuel D'utilisation page 113

It is not permitted to use inflation devices (e.g. gun) connected to power sources
outside the machine.
Always observe national safety regulations, which can be more restrictive than this
manual, according to the principle that a higher standard prevails over a lower one.
If the tyre operating pressure, required for a certain
vehicle, exceeds the value of the inflation limiting
valve, it should be obtained by positioning the tyre
and wheel on a suitable safety device.
Pay attention to possible injuries.Carefully read, understand and follow the in-
structions below.
1. Overinflated tyres can explode, producing hazardous flying debris that may result in
an accident.
2. Tyres and rims that do not have the same diameter are "mismatched". Never attempt
to mount or inflate any tyre and rim that are mismatched. For example, never mount a
16" tyre on a 16,5" rim (or vice versa). It is very dangerous. Tyres and rims that do not
correspond could explode and cause accidents.
3. Never exceed the inflation pressure for the tyre indicated by the manufacturer.
Carefully check that the air hose is well inserted in the valve.
4. Never bring your head or other body parts close to a tyre during inflation or bead
insertion operations.
This machine is not a safety device against the possible risk of explosion of tyres,
air chambers or rims.
5. Maintain a suitable distance from the tyre changer while inflating. Do not approach it.
User's manual
DANGER
WARNING
DANGER
WARNING
EN
113