Overview Of Programming Facilities - ROBBE BL-CONTROL 900 Série Notice D'utilisation

5. Using the Programmer to change settings
The robbe Programmer, No. 8633, is designed to make program-
ming the speed controller easier; it also allows more specific pro-
gramming to suit particular models.
This compact unit is easy to handle, and provides a fast, reliable
means of programming using the integral LCD screen.
5.1 Connecting the Programmer
Motor controller
Helicopter
Select Battery
Cut Off Voltage
Cut Off Type
Motor Direction
Advance Timing
Acceleration
Start Power
Response of Governor
Governor On / Off
Motor Pole Num
Gear Ratio
Max. RPM
Average RPM
Down Load
Restore Mem.
Backup Mem.
Operating Instructions
Roxxy BL-Control 900 series
Programmer
motor connection
Drive battery
Boat / Car
Select Battery
Cut Off Voltage
Cut Off Type
Motor Direction
Advance Timing
Acceleration
Start Power
Reverse Function
Motor pole Num
Gear Ratio
Max. RPM
Average RPM
Down Load
Restore Mem.
Backup Mem.
11
5.2 Navigating using the Programmer
The Programmer could hardly be easier to use: the outer arrow but-
tons are used to move up or down in order to select the programming
modes of your choice. You can also use the arrow buttons to select
the model type by holding both buttons pressed in.
The purpose of the two centre buttons DEC (-) and INC (+) is to select
and / or change settings.

5.3 Overview of programming facilities

With a few exceptions, all the programming points are laid out in the
same way. To help you understand the arrangement, all the values are
listed in the table printed below.
Aircraft
Select Battery
Cut Off Voltage
Cut Off Type
Motor Direction
Advance Timing
Acceleration
Start Power
Air Brake Type
Airbrake On/Off
Motor pole Num
Gear Ratio
Max. RPM
Average RPM
Down Load
Restore Mem.
Backup Mem.