Pasting Operations - Advance B562HD Manuel D'utilisation Et De Pièces

oPening tHe
siDe coVeR
You can find a quick release at the top of each
side cover.
Pull each quick release in the direction of arrow
and you can open the cover (Refer to fig. 3)

Pasting oPeRations

Swing out material support brackets from under paste tank.
Put the material shaft in the center of the bolt of material and set it on the bolt supports (shown Fig. 4)
after sliding on material discs and locking setscrew.
Pour paste into the paste tank. (Refer to Fig. 6). Do not fill paste higher than lower line of adjustable
roller. Close and latch side covers. Rotate the reverse feed rubber roller to distribute paste.
Adjust the thickness of paste by moving the adjusting lever in the direction of the arrow (shown in Fig.
3), move adjusting levers on both ends. Check paste thickness by running finger over paste roller. Set
the adjusting levers at a suitable position at each end.
Fig. 4
bolt
side cover
quick release
adjusting lever
Fig. 3
Pull out the material and lay it on the paste
roller as (shown in Fig. 5) after opening the
side covers. Close and latch the side covers.
The material will be coming forward (paste
side up) from behind the reverse feed roller.
Two trestles in front of the machine holding
a board of about 26- 28 inches wide parallel
to the machine, can be used to fold your ma-
terial. Alternatively you can put two narrow
tables at right angles to the machine and
walk between them.
You can also fold directly against the ma-
chine without using a table or use our option-
al booking table. (Refer to page 5)
( continueD on neXt Page )
advance-equipment.com
reverse feed
Fig. 5
adjustable roller
bolt
Usually, changing the adjustment between tension roller and pasting roller is not needed for proper
material pasting. However, if material surface is extremely thin or uneven and pasting is not satisfactory,
loosen pan head screw (1) as shown in (Fig. 6) by using a screwdriver. With the screw loosened, tension
roller moves closer to the pasting roller which puts more pressure on the material. Only loosen screw
closest to you.
You are now ready for operation.
Hold both sides of material with both hands, and draw out towards the direction of arrow (Fig. 6). Keep
a constant pulling speed for even pasting.
Clearance between pick up roller and paste roller should be about 0.022- 0.025 inch. If necessary, adjust
by raising or lowering pick up roller supports bushings in tank.
Fig. 6
pan head screw
pasted material
adjustable roller
pasting roller
material
guide stay
shaft
side cover
pick up roller
tension roller
cutting base
paste
Page 7