Safety Instructions For Rotary Tools - GMC DEC003AC Mode D'emploi

c. Disconnect the plug from the power source and/or the
battery pack from the power tool before making any
adjustments, changing accessories, or storing power
tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
GB
e. Maintain power tools. Check for misalignment or binding
of moving parts, breakage of parts and any other
condition that may affect the power tool's operation. If
damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into account
the working conditions and the work to be performed.
Use of the power tool for operations different from those
intended could result in a hazardous situation.
5. SERVICE
a. Have your power tool se rviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.

Safety instructions for rotary tools

• Do not use an accessory marked with a lower RPM than
that of the maximum no load speed shown on the rating
label
• Always wear eye, ear and breathing protection
• Do not apply excessive pressure when using this tool
• Keep your hands clear of the cutting devices
• The manufacturer is not liable for any changes made to the
tool, or for any damage resulting from such changes. Even
when the tool is used as prescribed it is not possible to
eliminate all residual risk factors
WARNING. Damage to eyes, ears and lungs may occur if
appropriate safety equipment is not worn, and risk of injury
unless hands are kept completely clear of cutting devices
6