Safety First; Operating Precautions - RCF BM 3014 Manuel De L'utilisateur

SAFETY FIRST!

WARNING. Before installing and using this product, please read this instruction manual carefully and
keep it on hand for future reference. Follow all the instructions to the letter.
This product has been designed for installation only by qualified personnel having the technical know-how
and experience or specific instructions to ensure correct execution of all the operations involved and to
prevent any risk to personal safety. RCF strongly recommends that you have this product installed only by
professional installers or specialized firms.
1. Attention to the precautions – Always follow the precautions provided on this product and in the
instruction manual.
2. Technical service – The user should never attempt to make any repairs on this product unless otherwise
indicated in the instruction manual. All repairs should be made by qualified service technicians.
3. Installation – Do not install this product in any way that is not provided for in the instruction manual.

OPERATING PRECAUTIONS

To prevent the occurrence of feedback, which causes the emission of the typical "whistling" noise, do not
position the microphone in the vicinity of loudspeakers, in order to reduce the possibility that the loudspe-
aker signal is picked up by the microphone. Never bend or jerk the connection cable. Do not use solvents,
alcohol, benzene, or other volatile substances to clean the external parts of the unit.
DESCRIPTION
BM 3014 microphone stand features high sensitivity and a broad frequency response. Factoryfitted for
direct connection with amplifiers of the AM4000 series, it is the ideal choice for any type of PA system.
The stand is made of plastic that is particularly resistant to friction, and the 12.60" (320 mm) gooseneck
is entirely chromium-plated in black to resist scratching and eliminate undesired reflections.
INSTALLATION
The stand can be stood on any flat surface. Two M4 threaded holes on the botton of the stand enable
securing it to the support surface.
VERY IMPORTANT. The M4 securing screws must go into the base by no more than 0.20'' (5 mm) to
avoid shortcircuiting the internal electronic card.
USE
The TALK button on the stand is used to activate the microphone, which remains on only as long as the
button is pressed.
2