Tools Required - Octane Fitness LATERALX CROSS CiRCUIT PRO KIT LX8000 Instructions De Montage Et Mode D'emploi

CROSS CiRCUIT PRO KIT for LateralX
Kit Contents
 Left Side Weight Stand
 Right Side Weight Stand
 Assembly and Safety Instructions
 End Caps (2)
 Hardware Kit (see illustration)

Tools Required

 5mm hex key wrench (included)
 6mm hex key wrench (included)
 #2 Phillips screwdriver
Assembly Instructions
 Remove Phillips screws (Qty 3)
and plastic covers.
 Place weight stand on machine;
insert pin (A).
 Assemble bolt
washer (C) (Qty 2) and insert
at rear of stabilizer; tighten to
10 ft-lbs.
 Assemble bolt (B) and washer
(C) (Qty 1), insert in pin (A) and
tighten to 10 ft-lbs.
 Install end cap.
Repeat  -  for other side.
(B) and





ENG-1