Conducting Measurements; Single Distance Measurement - Storch Digi Dist Mode D'emploi

Conducting measurements

Hold the device at the point from which you want to measure, press the "Read" button
(2) to switch on the laser and then press it again to conduct the measurement.
Note:
The laser will switch off after 20 seconds of inactivity. If a measurement is not con-
ducted within the 20 seconds, press the "Read" button again to switch the laser back on.
Do not aim the laser at persons or animals and do not stare into the laser
beam or view it directly with optical instruments.
Delete function:
To delete the current measurement and display the previous measurement press the
"Delete/Arrow" button (3). If the device is currently in the area, volume or Pythagorean
Theorem mode, press the Delete button repeatedly to revert back to the mode for single
distance measurement.

Single distance measurement

1. Press the Power button (1) to switch on the device; it will default to the single
distance measurement mode (fig. 4).
2. Press the Read button to activate the laser; the
laser indicator will now flash from top to bottom.
Direct the laser at the point you want to measure;
3. Press the Read button again to conduct the mea-
surement.
4. The length is displayed on the bottom line of the
screen in large digits and the laser beam switches
off (fig. 5).
82
Fig. 4
Fig. 5