weltico RAINBOW POWER 1600 Mode D'emploi page 2

EN
WELTICO LED BULBS
RAINBOW POWER 1600
Technical specifications:
- Bulb with powerful colour LEDs, type PAR56.
- Standard power supply: 12 V AC.
- Lifespan (LED): ~ 25 000 heures.
Model: 1600 lumens (+/- 10 %)
Maximum absorbed power: 40W
- 10 colours / 5 sequences of linked colours.
- Change of colours or sequences (standard) by disconnection on the power switch "START/STOP".
- Optinal : Change of colours or sequences by the intermediary of the KIT Receiver-Controller-Modulator with wireless remote
control.
- Keep the pre-defined colour or sequence after the bulb is turned off.
Installation:
This LED PAR56 lamp is compatible with most type PAR56 submerged pool projectors.
Turn off the power supply to projectors and replace the bulb following the instructions in the projector's usage notice.
NB:
Consider changing the bulb's watertight seal on its support for a new seal then mount the RAINBOW POWER bulb ins-
tead of the original bulb. Failure to replace the watertight seal may cause water to seep between the lamp and its support,
leading to damage to the bulb.
Use a TORIQUE 230 Vac transformer.
Provide a supply of a power greater than 10% to the power absorbed by the bulb. For example: A 300 Watt power allows
the lighting bulbs of 7 RAINBOW POWER 1600. 7 x 40 = 280 W.
The voltage drops can be very strong on bad connections, lugs and son Loose oxidized. Measure the voltage at the end of
the cable without the bulb.
Minimum required voltage: 10.5 V.
Maximum supported voltage: 13.5V.
Instructions for use:
When the power is turned on, the bulb lights up. To change the colour or sequence, press START / STOP on the power
switch in manual mode. The change procedure requires the switch to be pressed for less than 1 second.
The first time it is pressed, the bulb initialises on the first fixed colour.
Each subsequent time it is pressed, the fixed colours are displayed until the tenth, and then the five linked sequences are shown
until the first fixed colour returns.
Pressing for more than 10 seconds leads to memorisation of the current colour or sequence, making it possible to restore the
lighting with the pre-defined colour or sequence.
For optimum light in your pool, always keep the bulb with the arrow on the front up like the sketch:
Use authorised in all member states with no usage restriction. Compliant with directive R&TTE 1999/5/CE