Top View - SUPAflat 88-000002 Notice D'utilisation

Securing and using the baby harness on the SUPAflat Highchair.
The baby harness included in delivery can be fixed to the SUPAflat Highchair, ready for use, with a few simple steps.
A
Take the ends of the harness through the
slots on the backrest that are intended for
this. In doing so, pay attention to the orien-
tation of the back-plate of the harness.
D
Take the end of the upper strap firstly
through the back-plate and then through
the anchor on the chest area. Tighten all
parts of the harness.
Also available: SUPAflat wall brackets.
There is also a wall bracket available in three designs for the SUPAflat Highchair (for 1 chair, 2 chairs or 3 chairs).
The wall bracket is not included in delivery, and can be ordered as an extra component from local retailer.
INFORMATION ON OPTIMAL USE. PLEASE READ CAREFULLY BEFORE USING SUPAFLAT FOR THE FIRST TIME!
Product information
SUPAflat is made of beech wood. The finish contains no harmful sub-
stances. The emission of formaldehyde from the finish/wood corre-
sponds to European standard E1 (EN 717-1).
Safety standard
The SUPAflat Highchair is in line with the EN 14988:2012 standard.
Cleaning and maintenance
Use a clean cloth that is dry or damp. Please wipe off liquids (water,
super) with a dry cloth immediately. Please be aware that moisture
has a detrimental effect on the surface.
The use of cleaning agents is not recommended. The colour of the
highchair may fade if exposed to sunlight.
PLEASE NOTE!
- The SUPAflat Highchair must only be used if all the components
are attached and set accurately.
- The SUPAflat Highchair must not be used if any of the compo-
nents are missing, broken or torn.
Warning notices relating to your child:
- Only use a highchair when your child can sit unaided.
- Never allow your child to sit in the highchair unattended.
- Never let your child play in the vicinity of the highchair if it is not
positioned as intended for use.
- Always stay within reach of your child.
- Small parts, dangerous substances, hot objects etc. must not be
within your child's reach as these may cause injuries.
B
Take the straps through the anchors sup-
plied and go through the slots on the back-
rest from the back.
1
Bring the two straps from the back to the
front over your child's shoulders. Set the
length of the straps according to your child's
size.
Warning notices relating to the SUPAflat Highchair:
- Always place the SUPAflat Highchair on a flat, stable surface.
- Only use the SUPAflat once the safety mechanism is set with an
audible click. Please ensure that the footrest is correctly folded
flat before you place your child in the highchair.
- Never use the SUPAflat as a ladder.
- Only use SUPAflat accessories and components, otherwise you
may be putting your child at risk of injury.
- The SUPAflat Highchair must not be positioned near open fire or
an electric or gas heater.
Safety notices relating to the use of the baby harness:
- The SUPAflat Highchair must always be used with the correctly
attached baby harness.
- Ensure that the safety mechanism of the baby harness is precise-
ly anchored in the seat plate of the highchair.
Notices on use near the dining table
Please be aware that your child may put his or her feet on the dining
table for support and push – this may result in the highchair tipping
backwards.
Floors that are not smooth and even (carpets, tiles)
Please ensure that the SUPAflat is positioned on a flat and stable
surface. Surfaces that are not smooth and even are not suitable for
the use of the SUPAflat Highchair as it may tip.
End
C
Pull on the straps until the 2 anchors are po-
sitioned on the backrest as shown in picture.
Top view
2
Plug the safety mechanism of the straps into
the lock in the front area of the seat-plate.
Turn clockwise until you hear a loud click
as it engages. In order to unlock, press lock
button on the safety mechanism and turn
counterclockwise.
click!
5