Hama FreeStereo Twins Mode D'emploi page 9

LED (3) will light up in red briefly before the device turns off.
The first time the device is turned on, pairing is automatically started
– see 5.2 Bluetooth pairing – Headsets.
5.2. Bluetooth pairing – Headsets
• First the two headsets must connect to one another.
• Ensure that both headsets are switched off.
• Press and hold the multifunction button (5) on both headsets for
approximately eight seconds until the status LEDs (3) begin to
alternate between a red and blue light.
• The headsets automatically pair with one another within about
ten seconds. After that, you can connect the headsets to a
terminal device.
• If the two headsets cannot set up a connection within two
minutes, they will automatically switch off.
Note
• Once the headsets have correctly paired with one another,
one headset will automatically be guided by the headset that
was switched on/paired first.
• Therefore, when connecting the headsets to terminal devices
in future, you merely have to switch on both headsets and put
one of the headsets into pairing mode. The other headset is
automatically connected.
7