Garmin TREAD Instructions D'installation page 4

Mounting the Device on a Roll Bar
1 Using a flat head screwdriver or
ring separates.
2 Place the mount around the roll bar.
3 Tighten the bolt on the mount until the ring is secure.
4 Insert the ball on the mount
5 Tighten the knob
6 If necessary, rotate the mount
operation.
7 Tighten the knob to secure the mount.
8 Press the device into the mount until it snaps into place.
9 Route the power cable along a suitable path in your vehicle, and secure it using the included zip ties.
Removing Your Device from the Mount
1 Press the release button on the top of the mount.
2 Lift out the device.
4
9
/ in. (7 mm) nut driver, loosen the bolt
32
into the double-socket arm
slightly.
so the Garmin logo faces up, and adjust the mount for better viewing and
on the roll bar mount until the
.
Installation Instructions