Introduction; How Does The Whirl System Function; How Does The Air System Function; Functions Of Laola System - HOESCH Laola II Instructions De Montage Et D'utilisation

08

Introduction

08.01 How does the whirl system function?

The water system creates closed water circulation. The drain valve is also the suction nozzle. Water is sucked in, driven
by water pump and runs through water jets into the bathtub with about 1 bar pressure. With the vacuum we achieve self-
aeration of water stream. Cables between water jets and the water pump are so arranged that they are emptied during
releasing the water after having a bath.

08.02 How does the Air system function?

The air sucked by the blower is carried by air pipes located under the bottom of the bathtub and via bottom nozzles to the
inside of the bathtub full of water.
09

Functions of Laola system

09.01 Control panel

GB
1 Switch off everything
switching all functions off .
2 air pump on/off.
Short pressing of button 2 turns the pump on with 100% power.
Pressing this button during operation turns the pump off .
3 air pump power control button and wave effect button
from air jets. Active when air pump is on. Short pressing of
button 3 changes the air pump performance. The adjustment is
as follows: at further pressing the button reduced the revolution
speed to the minimum value. After the pump has reached the
minimum speed, and button 3 is still pressed, the speed of the
pump is increased to the maximum value. The pump speed
control range: 30 – 100%. Holding button 3 for 5 sec. switches
on wave eff ect from the air jets. By Pressing button 3 while the
wave eff ect is active, the wave eff ect switches off and speed
stabilizes at the current level.
4 lighting on/off
5 power control button of water pump. Button active during
water pump operation. Each button pressing changes water
pump performance. The adjustment is as follows: further
pressing reduced the revolution speed to the minimum value.
After the pump has reached the minimum speed, and button 5
is still pressed, the speed of the pump is increased to the
maximum value. The pump speed control range: 50 – 100%.
Holding the button 5 for minimum 5 sec. switches on the wave
eff ect from air jets. Pressing button 5 while the wave eff ect is
active, the wave eff ect switches off and speed stabilizes at the
current level.
6 button water pump on/off. Short pressing of button 6 turns on
the pump with the nominal power of 100%.
Pressing the button shortly during operation, turns off the pump.
Pressing 6 and holding it for minimum 5 seconds (while pump is
on) runs pulsating massage (water pump will work in repeated
cycles: 3 seconds maximum speeds, 2 seconds – minimum
speeds).
20
7 8 9
1 2 3
10 11 12
4 5 6
7 red LED indicates power supply and operation
readiness of the unit,
continuous lighting – controller in on, required water
level is reached
no lighting – no power supply of the controller,
"slow" blinking light (1 second) – "STANDBY" mode
– power supplied to the controller, no operation,
(time measurement to drying cycle)
8 red LED indicates blower operation.
continuous light – air pump on,
(time measurement to drying cycle),
no lighting - air pump off
9 red LED indicates blower speed change,
continuous light – wave eff ect active from air jets
(continuous change of speed).
no lighting – wave eff ect not active
10 red LED indicates light operation.
11 red LED indicates water pump speed change,
continuous light – wave eff ect active from water jets
(continuous change of speed).
no lighting – wave eff ect not active
12 red LED indicates water pump operation.
continuous lighting – water pump on
no lighting – water pump off