Fein STS325R Mode D'emploi page 4

OBJ_BUCH-0000000116-003.book Page 4 Tuesday, December 6, 2016 11:00 AM
en
4
If devices are provided for the connection of
dust extraction and collection facilities,
ensure these are connected and properly
used. Use of dust collection can reduce dust-
related hazards.
Pneumatic tool use and care
Do not overload the pneumatic tool. Use the
application tool intended for your work. The
correct pneumatic tool will do the job better
and safer at the rate for which it is designed.
Do not use a pneumatic tool that has a defec-
tive switch. A pneumatic tool that cannot be
controlled with the switch is dangerous and
must be repaired.
Disconnect the energy supply before making
any pneumatic tool adjustments, changing
accessories, or placing the pneumatic tool
aside. This precaution prevents accidental
starting of the tool.
Store idle pneumatic tools out of the reach of
children. Do not allow persons unfamiliar with
the pneumatic tool or these instructions to
operate the pneumatic tool. Pneumatic tools
are dangerous in the hands of untrained users.
Maintain the pneumatic tool with care. Check
for misalignment or binding of moving pneu-
matic tool parts, breakage of parts and any
other condition that may affect the pneumatic
tool's operation. Have damaged parts
repaired before using the pneumatic tool.
Many accidents are caused by poorly main-
tained pneumatic tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
Use the pneumatic tool, accessories, applica-
tion tools, etc. according to these instructions
and as specified for this specific type of pneu-
matic tool. Take into consideration the work-
ing conditions and the activities to be carried
out. Use of pneumatic tools for operations
different from those intended could result in
hazardous situations.
Use the auxiliary handle provided with the
pneumatic tool. Loss of control over the
pneumatic tool can cause injuries.
Hold the pneumatic tool firmly with both
hands and keep proper footing and balance at
all times. The pneumatic tool is guided more
secure with both hands.
Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
Keep your hands away from the saw blade. Do
not reach in front of or below the saw blade.
Contact with the saw blade can lead to injury.
Saw blades can become very hot while work-
ing.
Apply the pneumatic tool to the work piece
only when switched on. Danger of kickback or
loss of control over the pneumatic tool.
Do not rivet or screw any nameplates or signs
onto the pneumatic tool. Adhesive labels are
recommended.
Do not use accessories that have not been
especially designed or released by the pneu-
matic tool manufacturer. Safe operation is not
ensured only because an accessory fits your
pneumatic tool.
Pay attention to hidden conductors/leads, gas
and water pipes. Before beginning to work,
check the working area, e. g., with a metal
detector.
Service
Have your pneumatic tool repaired only
through a qualified repair person and only
using original replacement parts. This will
ensure that the safety of the pneumatic tool is
maintained.