Changing The Tool - Fein STS325R Mode D'emploi

OBJ_BUCH-0000000116-003.book Page 11 Tuesday, December 6, 2016 11:00 AM

Changing the tool

Disconnect the energy supply before making any pneumatic tool adjustments,
WARNING
changing accessories, or placing the pneumatic tool aside. This precaution pre-
vents accidental starting of the tool.
Mounting the saw blade (figure 3).
Remove the two hexagon nuts on the stroke
rod with the open-end wrench.
Remove the clamping plate.
Mount the saw blade and clamping plate onto
the stroke rod.
Tighten the hexagon nuts again.
en
1.
2.
3.
11