Fein STS325R Mode D'emploi page 15

OBJ_BUCH-0000000116-003.book Page 15 Tuesday, December 6, 2016 11:00 AM
Correct setting of the oiler: (figure 7).
Under operating pressure (6 bar min.) and
with the filler plug open, the oil must bubble.
One oil filling is sufficient for approx. 8 oper-
ating hours.
After removing the screw plug, the setting
screw can be accessed.
Tightening (turning clockwise) the setting
screw reduces the oil feed, releasing (turning
counterclockwise) the setting screw increase
the oil feed to the machine.
In most cases, tightening or releasing by ¼ to
½ thread will be sufficient.
Allow a Ø 2 mm clearance in the passage
hole.
Check the correct oiler setting by applying a
paper test: Hold a white sheet of paper in
front of the air outlet of the machine; the oil
film being expelled may not start to drip off.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed. In addition, FEIN also provides a guarantee in accordance with the FEIN
manufacturer's warranty declaration.
The delivery scope of your pneumatic tool may include only a part of the accessories described
or shown in this Instruction Manual.
Environmental protection, disposal.
Packaging, worn out pneumatic tools and accessories should be sorted for environmental-
friendly recycling.
For further information, please contact your specialist shop.
Fig. 7
Filler plug
en
15
Setting screw
Screw plug