Progressive Scan / Av2 Connection; Video Output Format / Power Save Mode; Factory Set; Language Settings - LG DR275 Manuel Du Propriétaire

General Settings (Continued)
Progressive Scan
Progressive Scan Video provides the highest quality
pictures with less flickering.
If you are using the COMPONENT OUTPUT jacks,
but are connecting the recorder to a standard (analog)
television, set Progressive Scan to [OFF].
If you are using the COMPONENT OUTPUT jacks for
connection to a TV or monitor that is compatible with
a progressive scan signal, set Progressive Scan to
[ON].
Note:
Progressive Scan will be disable in the setup menu
when the Video Output Format in the setup menu is
set to RGB.
Caution
Once the setting for Progressive Scan output is
entered, an image will only be visible on a
Progressive Scan compatible TV or monitor. If you set
Progressive Scan to [ON] in error, you must reset the
recorder. First, remove the disc in the recorder. Next,
press STOP (x) and hold it for five seconds before
releasing it. The video output will be restored to the
standard setting, and a picture will once again be
visible on a conventional analog TV or monitor.
AV2 Connection
You can connect a decoder or other device to the
AV2 DECODER socket on the back.
[Decoder] Select [Decoder] if you connect the
recorder's AV2 DECODER jack to a PAY-TV or
Canal Plus decoder.
[Other Device] Select [Other Device] if you connect
the recorder's AV2 DECODER jack to a VCR or
similar recording device.
Video Output Format
Select the Video output format option according to the
connection type of this unit
[YPbPr] When your TV is connected with the
COMPONENT OUTPUT jack on this unit.
[RGB] When your TV is connected with the
SCART(RGB signal) jack on this unit.
Power Save Mode
You can set up the unit into an economic power save
mode. Nothing is displayed in the display window
when the unit is turned off.
[OFF] Power Save Mode is not active.
[ON] Power Save Mode is active.
Notes:
The encoded television signals (CANAL+ or
PREMIERE) are not decoded in the Power Save
Mode.
The Power Save Mode is not available in the
standby mode for the timer recording and when
power off of the unit after receiving the encoded
television signals (CANAL+ or PREMIERE).

Factory Set

If you need to, you can reset the Recorder to all its
factory settings. Select ''ENTER'' icon then press
ENTER and auto setup menu will appear, see page 14.
Note:
Some options can not be reset. (Rating, Password,
and Area Code)

Language Settings

Display Menu

Select a language for the Setup menu and on-screen
display.

Disc Menu/Audio/Subtitle

[Original] Refers to the original language in which
the disc was recorded.
[Others] To select another language, press number
buttons then ENTER to enter the corresponding
4-digit number according to the language code list
in the reference chapter (see page 43). If you make
a mistake while entering number, press CLEAR
repeatedly to delete numbers one by one then
correct it.
[OFF] (for Disc Subtitle) : Turn off Subtitle.
17