Hoover IRONspeed SFD4102 Mode D'emploi page 12

ing
2
11 - GB 11 -
Ironspeed_SF__1-12_union.indd 11
Troubleshooting
Problem
The appliance does not
become hot
The appliance does not
produce steam
Steam escapes from the
calc removal cap when
ironing
The empty water tank
LED is on
The soleplates becomes
dirty or brown
Water stripes appear on
the textile
Some scale deposit
appears on the soleplate
Cause
There is a connection
problem
The appliance is not
switched on
The soleplate temperature
is too low
The appliance is not
switched on
The boiler has not yet
heated up
The water tank may be
empty
You are not pressing the
steam trigger
The soleplate temperature
is set to the maximum
The calc removal valve is
not tightened enough
The anti-scale valve is
damaged
There is no more water in
the tank
There should be chemical or
additives in the water used
for ironing
The linen is still dirty
Your ironing board cover is
saturated in water
Your boiler has not been
rinsed for a while
Solution
Check the mains cord, the
plug and the wall socket
Press on the on/off switch
Set a higher temperature
of the soleplate
Press on the on/off switch
Wait a few moments until
the steam ready LED is off
Refill the water tank
Press the steam trigger
It works but steam is not
visible as very hot and dry.
Switch off the appliance
and let it cool down.
Remove the calc removal
cap and tighten the valve
correctly
Contact your after sales
service
Refill the water tank with
water
Never use any chemical or
additives in the water.
Contact your after sales
service if the linen is still
dirty
Clean the soleplate with a
non-metallic sponge
Change the cover or use a
mesh ironing board
Follow the indications in
the appropriate chapter
19-10-2009 17:57:56