Fagor DH-315 D Manuel D'utilisation page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

interior
26/10/04
Each time you press the
you decrease the humidity value by
5%RH, down to 30%RH. If you press
the button again, the
appear, which indicates "continuous"
operation. In this case, the compressor
will continue to operate, without
affecting the humidity level, until the
tank is filled.
NOTE: If the preset humidity level is
higher than the ambient humidity, the
compressor will stop and the fan will
continue to operate.
Press the
stop working. Next time you switch the
appliance on, it will operate with the
level of humidity set the time before.
2. How VENTILATION operates
Press the
appliance on and the
select VENTILATION mode; the
symbol will appear on the liquid crystal
display. In this mode, the air inside the
room is ventilated and purified without
changing the humidity.
3. Adjusting the air flow
Press the
speed.
High fan speed, at which the unit
dehumidifies rapidly;
Low fan speed, at which
dehumidification is carried out slowly,
but more quietly.
4. Display unit
This unit is fitted with a display. At first
the ambient relative humidity appears
on the screen. If you want to find out
the temperature in the room, press the
button and the ºC will appear for 5
seconds. After which the original display
will return.
5. Adjusting the air flow outlet
10:03
Página 17
button,
, symbol will
button, the unit will
button to switch the
button to
button to select the fan
This unit has two air flow outlets:
upwards, adjusting the grille at the back,
and backwards. The appliance comes
with the grille closed and you have to
open it each time you switch on the
appliance.
NOTE: Close the ventilation grille
after use to prevent any objects from
getting inside the unit.
8. DISPOSING OF CONDENSATION
WATER
Condensation water can be disposed of in
two ways:
A. Removable water tank
The condensation water is collected directly
in the tank. When it is full, an indicator light
will light up on the control panel,
the alarm will sound and the
appliance will automatically switch off.
This tank is easy to remove for
emptying. Once empty, make sure that
you put it properly back into place so
that the indicator light goes off,
otherwise the appliance will not work.
When the light comes on and the
compressor stops, wait a few minutes
before removing the tank from its
18

Publicité

Table des Matières
loading

Table des Matières