Manual Mode - RedHotDot 054776 Notice D'utilisation

MANUAL MODE

In this mode, heating power can be changed by the user, and heating time is managed according to pressure
on the button (with a maximum limit of 2 seconds). Heating power can be set to the following values: 150,
180, 210, 240, 270, 300, 330, 360, 390 (Watts).
ADVICES
For large dents, we recommended starting at the base and finishing in the centre. Start heating around the
dent (1), raising the sheet metal slowly whilst moving toward the centre to straighten up (2); This makes it
easier when the inductor is on the top of the dent (3).
In certain cases the dent depth might increase whilst being heated (the sheet metal can go down as a result
of the heat). If this is the case, increase the heat on the perimeter of the dent and continue to heat until it
starts to decrease. For deep dents, heat in a circular motion around the dent, towards the centre.
Dent pulling
inductor
6
EN