Automatic Mode - RedHotDot 054776 Notice D'utilisation

This manual contains safety and operating instructions. Read it carefully before using the device for the
first time and keep it in a safe place for future reference.
This inductor is compatible with your 2.4 kW induction heating system (version 2 or
above). To check the version of your product, turn it off and on again with the ON/OFF
switch. For 2 seconds, the version will be displayed:
- 2XX (compatible)
- 1XX (not compatible)
To update your product to version 2 or above, you will need to change the command
electronic board. Contact your dealer or distributor.
DESCRIPTION
The dent pulling inductor has been designed for paintless dent repairs on car bodies e.g dents made by
hail stones. It is not necessary to clean the reverse side in order to restore the surface. Only the exterior is
affected.
Warning! Although the dent pulling inductor stays cold, prolonged heat on the car
body might damage the paint.The manufactorer accepts no responsibility for damages
caused to your vehicle due to misuse.
PRINCIPLE
The dent pulling inductor facilitates the elimination of dents using a thermal expansion of the metal sheet.
When placed on a dent, the inductor will heat the metal between the 2 inductor feet. The surrounding cold
metal maintains the heating part in compression. The heat on the sheet will provide a suction in the direction
of the inductor, removing the initial dent.

AUTOMATIC MODE

In this mode, heating power is limited to 0.5 seconds to avoid burning the paint. The heat is controlled by
pressing the accessory button. Be aware that repetitive pressing, without moving the inductor may result in
burnt paint. If heating is required in the same place on the car body, we advise leaving the sheet metal to
cool.
Dent pulling
inductor
5
EN