GE 040350 Manuel De L'opérateur page 17

General Set Up Screen
For general set up, press and hold the left arrow and right arrow
NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was also set at
NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was
the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time. To update or change these
also set at the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time.
settings, follow the steps below.
To updated or change these settings, follow the steps below.
"GENERAL SET-UP"
WILL SCROLL
SET DATE
or
SET TIME
or
SET EXERCISE
CYCLE
EVENT
LOG
YEAR
ok
FLASHING
or
HOURS
ok
FLASHING
or
If set to OFF, display will read: EXERCISE CYCLE OFF
OFF
or
DAY OF WEEK
ok
FLASHING
or
Display will scroll last service code event, date, time, and
ok
temperature of when the event occured.
IF DURING PROGRAMMING NO BUTTONS ARE PRESSED FOR 30 SECONDS,
IF DURING PROGRAMMING NO BUTTONS ARE PRESSED FOR 40 SECONDS,
THE CONTROL PANEL WILL AUTOMATICALLY EXIT THE PROGRAM MODE.
THE CONTROL PANEL WILL AUTOMATICALLY EXIT THE PROGRAM MODE.
ok
ok
for 3 seconds. Follow the prompts as outlined below.
MONTH
ok
ok
FLASHING
or
MIN
ok
ok
FLASHING
or
HOURS
ok
ok
FLASHING
or
DAY##
ok
FLASHING
or
AM/PM
ok
FLASHING
or
MIN
AM/PM
ok
FLASHING
FLASHING
or
or
ok
ok
or
ok
or
17