Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Mounting the wall mounted and ceiling suspended housing
1.
Use the enclosed screws (M6) with O-type sealing rings and dowels to secure the enclosed mounting plate to the wall or ceiling.
2.
Type EDC-OPS/C: If the housing is mounted in the outdoor area or in an area with intense insolation, the sunshield
over the indoor housing
102
Type: EDC-IPS/C: The system does not contain a sunshield
3.
Wrap the enclosed Teflon tape
4.
Push all required cables through assembly plate
5.
Screw the tube wrapped in Teflon tape into the enclosed assembly plate until firmly in place. If the length of the tube exceeds 1m, a metal socket
must be screwed in-between. Every extension must have a PT1 1/4"-screw thread.
6.
Camera bracket
is pre-assembled in the indoor housing
200
tube and twist until firmly in place.
7.
Connect 24VAC-cable for heater and fan (outdoor housing only) to the connector board
camera (cables are not enclosed).
8.
Rescrew camera bracket
200
connector plate.
9.
Screw dome connector plate of the camera housing into the spacer bolts with internal screw thread of the camera bracket
3 enclosed screws. Connect power supply and data cable to the contact strip with the plug of the camera.
Note: When connecting several cameras, the second 24VAC-connector can be used as an output.
10.
Install dome-ID (identification) (refer to operating instructions of the dome camera)
11.
It is recommended, not to assembly the dome enclosed with the camera and to remove the window in front of the lens (refer to fig. A and B).
12.
Insert the dome camera into the dome connector plate. The indicator „lock open" must thereby snap into place in the nib of the connector plate.
Twist the dome camera to the right until a clear click can be heard. Check whether the camera is securely in place.
13.
Remove safety strip from the dome camera.
14.
Insert bubble
with housing ring
105
into the indoor housing
102
talcum or the like. The 3 nibs in the ring serve as a guide on insertion into the internal housing.
Fan & heater board
Loosen 3 screws
Dome base
Dome base board
Dome connector
Dome camera
Housing ring
. The hexagon spacer bolts with internal screw thread
(metal bubble); no hexagon head screws are assembled on the indoor housing.
112
around the screw thread of the pipe (respectively approx. 20 wraps).
520
and tube.
101
102
to the indoor housing. Connect the external video cable (with BNC-connector) to the video cable of the dome
incl. sealing ring
(the components
104
103
(M4-screws
are enclosed). For easier insertion or removal, the sealing ring should previously be treated with
107
Bubble
Srew
A
are pre-assembled on the internal housing.
106
and must be unscrewed. Insert the drop shaped indoor housing
; lay onward from the connector board to the dome
400
,
and
are provided pre-assembled as 1 component)
105
104
103
push
B
24VAC
24VAC
OUT
IN
9
(metal bubble) is placed
112
into the
102
by means of the
200
Remove window
push
Seal using silicone rub-
ber around the circle
Publicité
Table des Matières
