Fingerprint Reader (Option) - Captiva G14M 20V3 Guide Utilisateur Concis

Fingerprint Reader
Enroll your fingerprints as instructed below before use.
The fingerprint reader module uses the Sign-in options
configuration of the Windows Account.
Fingerprint Sign-In Issues
If at the Windows Hello screen, the Fingerprint reader
fails to recognize the fingerprint 3 times it will then block
access to the computer. In this case you will need to use
your PIN (the PIN you used when initially setting up the
fingerprint reader) to access the computer. Alternatively
you can sign-in using your windows password. After us-
ing the PIN code (or windows Password) to access the
computer you can go to the Settings > Accounts >
Sign-in options if you wish to change any settings.
Fingerprint Module Configuration
1. Click the Settings item in the Start Menu.
2. Click Accounts and then click Sign-in options.
3. You will need to add a Windows password (click Add under
Password).
4. After you have added the password you will need to also add a
PIN.
5. Under Windows Hello click Set up under Fingerprint.
6. The wizard will then guide you through the set up process to
enroll your fingerprints.
28
(Option)
7. The fingerprint sensor in the Touchpad will flash, so repeatedly
8. You will be instructed to Touch the fingerprint sensor a number
9. Try to present different parts of your finger in different positions
10. Click Close when complete.
11. You can choose to Add another finger (this is recommended) or
12. You can now touch the fingerprint sensor to log-on to the
rest your finger on the sensor, and then lift it off until the setup is
complete as instructed.
of times (this may be in excess of 20 times).
similar to the various positions you may use when using it, and
note the following:
• Hold the finger on the sensor for at least half a second.
• Make sure that you make firm direct contact with the sensor,
and cover the entire area of the sensor with the finger (you are
looking for a reading of at least 75% of the finger area).
• Use a pressing motion as opposed to a touching or tapping
motion.
• When authenticating use the same sort of angle you used for
enrollment.
Remove the current fingerprint reading.
computer.
Figure 23
Accounts
- Sign-in
options