Carson DRAGSTER XXS Mode D'emploi page 3

INSTRUCTION MANUAL
DRAGSTER XXS Brushless-Sensored Speed Controller
SPECIFICATION:
Input Voltage: 7.2V to 8.4V (6-7 cells NiCd, NiMH) or (2 cells Li-polymer)
BEC Output: 5V / 1A
RPM: 3800KV with 12 turns sensor motor
4800KV with 9 turns sensor motor
IMPORTANT!!!!
Before using your DRAGSTER XXS Brushless Controller for the first time please note the
following:
- Please read this manual carefully before using your new CARSON Brushless Controller!
- Always make sure that you have the right gear ratio. The vehicle must not be geared low
over a long period.
- Do not connect the battery cable (plus and minus) with reversed polarity. The guarantee is
not valid if a short circuit occurs.
- Select the correct battery type / under-voltage protection (Cut-Off/ LiPo-batterys).
- If the car stops suddenly when speeding up it means that the speed controller or motor is
Overheated. Turn off the power and cool down the speed controller or motor.
How to use:
1. Firstly connect the signal cable to the receiver and the cables to the motor correctly. Please make
sure the connection is correct, then connect the power to the speed controller.
2. It will not allow the motor to run if there is no signal from the transmitter. When signal is
connected, the user can do the setup by pressing the button.
3. The user can do the setup only when there is signal from the transmitter (Please see "Setup")
DRAGSTER XXS BRUSHLESS CONTROLLER
50 090 6074 XXS 12 Turn combo
50 090 6076 XXS 9 Turn combo
GB
3