PMC adaptec SAS RAID Mode D'emploi page 6

Note: Although you can start using the array now, performance is reduced
until the build process is complete.
k
Press Esc until the Exit Utility window appears.
l
Select Yes, then press Enter. The computer restarts.
Step 5 Set up the Boot Sequence
The process you use to access your computer's BIOS Setup program and set the
boot sequence varies by computer manufacturer. Refer to the instructions
provided with your computer. Steps may be similar to:
a
During startup, press the key combination that starts the BIOS Setup
program (for example, <F2>, <F1>, <DEL>).
b
Go to the menu used to specify the boot sequence. Put the DVD drive first—
this allows you to perform
c
Go to the menu used to specify the boot priority for Hard Disk Drives. Put
the Adaptec RAID controller first in this sequence.
d
Save your changes and exit Setup.
Step 6 Install the Controller Driver with the OS
Windows Server 2012, Windows Server 2008, Windows 7,
Windows 8
a
Insert your Windows CD, then restart the computer.
b
Follow the on-screen instructions to begin the Windows installation.
c
When prompted to specify a location for Windows, select Load Driver.
d
Insert the USB driver disk, browse to the driver location, then click OK.
e
When the driver is found, press Next.
Note: If you see the message 'No drives were found', repeat
(browse to the driver location), and
will load successfully.
f
Click Next again to accept the default partition configuration, or refer to your
Windows documentation to configure partitions manually.
g
Follow the on-screen instructions to complete the installation.
Step 6, below.
Step e. On the second attempt, the driver
5
Step c, Step d