Desa 80-CC Manuel D'utilisation page 6

Radiateur de chantier au propane
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
Continued
8. When burner remains lit, set heater at the desired
heat level by slightly depressing the control knob
and turning it counterclockwise to the MED or
HI settings (see Figure 5, page 5).
9. If burner goes out, turn off gas. Slightly depress
and turn control knob fully clockwise to OFF.
Check fuel supply. If adequate fuel is available,
restart heater beginning at step 1, page 5.
FLAME PATTERNS
Figure 6 shows a correct flame pattern. The burner
flame is mostly blue with a slight yellow coloring
on the ends.
Figure 7 shows an incorrect flame pattern. The
flame is mostly yellow. The incorrect flame pattern
results from low gas pressure or from flashback.
CAUTION: Running heater
below specified input rating may
cause flashback. During flash-
back, the burner flame is mostly
yellow. The flame will burn inside
the burner tube, causing a roar-
ing noise. If flashback occurs,
turn heater off. After burner tube
cools, restart the heater.
Slight Yellow
Coloring on
Flame Ends
Burner
Tube
Figure 6 - Correct Flame Pattern at High
Position
6
Yellow
Flame
Flame Inside
Burner Tube
(makes
roaring
noise)
Figure 7 - Incorrect Flame Pattern During
TO STOP HEATER
1. Tightly close propane supply valve on propane
tank(s). Allow heater to burn remaining fuel
in hose.
2. Shut off burner. Do this by pushing in the
control knob and turning clockwise to the OFF
position.
TO RESTART HEATER
1. Wait five minutes after stopping heater.
2. Restart heater by following To Start Heater,
page 5.
derstand the warnings in the
Safety Information section, page
2. They are needed to safely op-
Blue
Flame
erate this heater. Follow all local
codes when using this heater.
200,000 BTU/HR HEATER
TO START HEATER
1. Before lighting pilot fully close the ball valve
(turn knob fully clockwise).
2. Fully open the valve on the propane cylinder and
wait 15 seconds before proceeding to step 3.
3. Depress red button on safety pilot valve admit-
ting gas to the heater. Then push and release
the ignitor button until the pilot lights.
www.desatech.com
Flashback
WARNING: Review and un-
Blue
Flame
116557-01A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rcp80vcRemcp80vcSpc-80ccTc80vc 200cRcp200vRcp200v a ... Afficher tout

Table des Matières